Hunter Hydrawise Ready, Manual, Page: 21 / 82

Cycle Controller Power
If you have voltage at both the wall outlet and the transformer output and you still have a
blank display, try cycling the power on the controller. To cycle the power on the
controller:.
1. Remove power by unplugging the transformer from the wall outlet or by turning off the
circuit at the breaker box.
2. Wait a few minutes.
3. Plug the controller transformer back into the electrical receptacle, or turn the breaker
panel switch back on.
Note: If this doesn't restore the display, the controller will need to be replaced.
Is Your Email Marked as Spam?
If you are experiencing issues communicating with support@hydrawise.com
[8]
, the
messages are most likely being as marked as spam. Add the email
address hydrawisesupport@hunterindustries.com
[9]
as an approved receiver so messages
will come through to us. We will update the ticket accordingly.
No Zones Running
In this article, we will cover the most common reasons why your sprinklers are not running.
Topics include the following:
Testing water supply
Copyright 2020 Hunter Industries. All Rights Reserved. 21