Hunter GSP9200 Touch, Operation Instructions Manual

Page: 70 / 88

62 EQUIPMENT INFORMATION
Figure 258.
Hood Autostart Feature
Enables or disables automatically starting the spin upon
closing the hood.
Servo-Stop
Enables or disables the intelligent DC motor drive to
automatically rotate the wheel to the weight positions.
Servo-Push may also be enabled, which allows pushing
the wheel (approximately 1/8 of a revolution) to cause
the intelligent DC motor drive to automatically rotate the
wheel to the next weight positions. Touching the “START”
key or the weight amounts or locations may still be
used for this function. Options are Enabled, Disabled or
Enabled with “Servo-Push”
Rim Dimension Manual Entry
In the event of a Dataset
®
arm failure, balancing can still
be performed by using a tape measure to manually input
rim dimensions.
Touch the “Wheel Dimensions” button.
Touch the “Manual Entry” button.
Figure 259.
In this example, no dimensions have been
entered.
Printout Paper Size Selection
Selects the size of paper for printouts.
Selectable Print Destination
From any printable screen or report, there is now an
option to print to multiple destinations. For example, if
there is a printer attached to the balancer and a thumb
drive is plugged into a USB port, the operator is given a
choice of where the print job should go.
Touch the “print” button. A pop-up dialog box will appear.
Figure 256.
When printing to a USB drive, the drive must
contain a volume “name”. The USB drive must
first be “named” using your laptop or another
PC then plug it in an open USB port. Use the
one on the neck for easy removal to print on a
PC.
Touch the arrow to the right of the listed printer. A list of
available destinations will appear.
Select the desired destination and touch “OK”.
Figure 257.
The same feature is available on customer report print
screens.