Hunter AutoComp Elite, Operation Instruction Manual, Page: 10 / 33

6 GETTING STARTED
Each mark represents 0.004 depth of cut on the adjust -
ment handle.
Cutting Tool Lock Knob (Inside and Out -
side)
Figure 4
Loosen these handles one at a time to set the depth of
cut. Lightly tighten them to hold the cutting tools in place.
Tool Holder Shaft Locking Bolt
Figure 5
By loosening the tool holder shaft locking bolt, the cutting
tool holder bar may be slid along the cutting tool slide.
This allows for proper alignment of the cutting tool holder
bar and the disc being machined. After proper alignment
is achieved, the tool holder shaft locking bolt should be
lightly tightened.
Trolley Height Adjustment
The trolley lift strut can be adjusted to accommodate low
and high operational ranges. The low range of travel is
20.25 in. to 36.25 in. (514.35 mm, 920.75 mm), as mea -
sured from the lathe output shaft centerline to the floor.
The high range is 24.5 in. to 40.5 in. (622.3 mm, 1028.7
mm) as measured from the lathe output shaft centerline
to the floor.
Lock the carriage in place using the provided locking pin,
then remove the stop bolt at the top of the column.
Figure 6
Push down on the carriage to unload the stop pin and
then remove the pin. Slowly release the carriage and
allow the strut to fully extend.
Figure 7
Lift the carriage to pull the strut out of the trolley base,
install the strut into the lower position.
Figure 8
Push the carriage down and pin it in position, then rein -
stall the stop bolt.
The lift strut contains highly pressurized gas
and is under compression in the trolley at all
times.