Connect Wires and Mount Thermostat Cover to Wall Plate
22
■
Carefully connect connectors 1 and 2 back to terminal socket.
(See Figure 4.)
■
Switch on the main power. Press the reset button to reset and start
the clock. Use a thin probe, such as a straightened paper clip, to
gently push the reset button through the hole in the front panel.
(See Figure 5.)
■
If you haven’t already done so, remove the mylar label from the
display window.
■
The LCD display should read 12:00 AM, showing the current room
temperature of your house. If it shows random numbers or partial
digits, press the reset button once again.
The installation is now complete. Complete operating instructions
begin at the front of this manual.
Figure 4
Figure 5
■
Match and connect the labeled wires to the appropriate coded ter-
minal connector on the mounting plate. (See Figure 3A.) Ignore any
wires which may be present, but which were not connected to the
old thermostat.
■
Push excess wire back into hole to prevent interference with mount-
ing of the thermostat cover.
■
Insert three AA size batteries into the wallplate as shown in Figure 4,
observing the polarity marked on the unit.
■
Make sure the Function switch is set at OFF, and the FAN-AUTO
switch is in AUTO. Push the connectors at the end of each
Thermostat wire onto the appropriate coded terminals on the
wallplate, matching the colors. (See Figures 3 and 3A.)
■
Line up the thermostat cover with wallplate, insert faceplate screws
and tighten.
Figure 3
Figure 3A
