MAINTAINING YOUR LAMINATOR _______________________________________________________________
CLEANING THE LAMINATOR
•
Clean the exterior painted surfaces of your laminator with a
damp cloth. Use a household detergent to remove any
difficult stains. Do not use an abrasive cleaner or it may
damage the paint surface.
þ
WARNING! Do not let water get into the control panels of
the laminator, as they are not sealed. Water may enter
the electrical circuits and cause personal injury and/or
damage the equipment when power is applied.
GREASING THE BEARINGS
•
You must grease the top and bottom roller bearings once
each month or every 200 hours.
þ
WARNING! Failure to lube bearings will cause premature
wear, which may cause costly repairs and will void your
warranty.
þ
WARNING! Authorized service technicians must unplug
the laminator before any servicing.
REPLACING FUSES
•
Replace defective fuses with fuses of the same type.
Replacement fuses are included in your accessory pack and
can be re-ordered through the Hunt Graphics location
nearest you, see the rear cover.
•
NOTE: You must use replacement parts specified by Hunt
Graphics. The fuses are located inside the left cabinet inside
the Electrical Panel Cover.
RESETTING BREAKERS
•
The breakers are located inside the left cabinet in the center
next to the lower infrared sensor. Turn the door interlock to
the OFF position and open the left cabinet door with door
key. Reset the tripped circuit breaker to the up position.
Call Technical Service for further assistance.
