Hunt Graphics IMAGE 410, User Manual

Page: 23 / 29

- 23 -
3
H
Problem – Images or prints are rippling as they are fed in.
n
While feeding an image into the nip, place your hand
on the image to create tension.Problem – The film is
coming out rippled or boat waking.
n
Make sure the machine is webbed properly.
n
There may be improper film tension. Try to readjust
it.
n
If you are using photo materials of heat sensitive
prints, run the laminator at a higher speed. Exposure
to heat at low speeds can cause waving.
Problem – The film is cloudy or mottled.
n
Increase the roller temperature or decrease the motor
speed.
Problem – Machine shuts down and display screen is
blinking.
n
See page 24 Error codes for definition of problem.
LOCATION OF BREAKERS
n
1. Motor Breaker (0.8 Amp)– Located under the drive
side plate.
n
2. Control Power (2 Amp) – Located under the control
side plate.
n
3. Top Heater (8 Amp) – Located under the control
side plate.
n
4. Bottom Heater (8 Amp) – Located under the control
side plate.
n
5. Common (16 Amp) for Domestic only – Located
under the control side plate.
Note: All breakers are visible and can be reset, from the
outside of the laminator.
1
5
4 3
2