532138-1_C
DUAL NMEA Y-CABLE
Installation Guide
1
O
VERVIEW
Use the Dual NMEA Y-Cable to connect two NMEA 0183 accessories to the ONIX® control head. We
encourage you to read this guide completely before you start the installation so you may understand
the installation requirements.
Customer Service:
Contact Humminbird Customer Service at
1-800-633-1468
or visit our Web site
at
humminbird.com
.
WARNING!
This product contains chemicals known to the State of California to cause
cancer and birth defects or other reproductive harm.
NOTE:
A separate power source is required for each attached accessory.
NOTE:
Product specifications and features are subject to change without notice.
1
|
Connecting the NMEA 0183 Accessories to the Y-Cable
Each accessory should include a NMEA 0183 data cable with bare wires for connecting to the
Humminbird Y-Cable. Refer to the accessory’s user manual for information about the data cable.
1. Turn off the power for the ONIX control head and each accessory.
WARNING!
Turn off power for all related equipment before you start the installation.
2. Use the accessory manual to locate the following wires on the Accessory Data Cable:
transmit A(+), transmit B(–), receive A(+), receive B(–), ground, and drain.
3. Choose one set of bare wires on the Y-Cable (Serial #1 or Serial #2).
BLUE
YELLOW
BROWN
ORANGE
BLACK
DRAIN
BLUE
YELLOW
BROWN
ORANGE
BLACK
DRAIN
Serial #2
(striped wires)
Serial #1
Continued on the other side...