Hughes HX100, Installation Manual

Page: 45 / 138

Chapter 4 • Commissioning the HX50/HX100 Remote Terminal
1037106-0001 Revision B.03-Draft
27
(NIC) is properly installed and that the installer laptop is
properly configured to use DHCP.
If the NIC is installed properly and the installer laptop is
configured properly, make sure all cable connections are
secure. If they are:
– unplug the remote terminal from the surge protector or
other power source
– shut down and power off the installer laptop
– plug the remote terminal back in
– turn the installer laptop back on
Also, make sure that neither an Ethernet router nor a switch is
currently connected to the remote terminal, then try the ping test
again. If the test is still unsuccessful, call technical support for
assistance.
Uploading the SBC
configuration file to the
HX50/HX100
The SBC configuration file (
sbc.cfg
) contains satellite
information that SBC and the auto-commissioning server (ACS)
must use during the commissioning process. Once you obtain the
sbc.cfg
file, save it on the installer laptop, making sure to note
the location in which the file is saved; then complete the steps
below.
1. Open a browser on the installer laptop.
2. Type
http://192.168.0.1/fs/registration/
setup.html
in the address bar and press E
NTER
. If an
alternate IP address was assigned to the remote terminal at
Figure 16: Failed ping
Note: If you do not have to upload an
sbc.cfg
file to the
remote terminal, skip this section and go to Commissioning
the HX50/HX100 on page 29.