Hughes HX100, Installation Manual

Page: 132 / 138

Appendix D • Conforming with standards and directives
114
1037106-0001 Revision B.03-Draft
Canada Class B warning This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme á la norme
NMB-003 du Canada.
R&TTE (EU) This product is within the scope of the EU Radio Equipment and
Telecommunications Terminal Equipment (R&TTE) Directive.
Telecommunications
standards
This section explains compliance with the IP over Satellite
standard (IPoS) and FCC Part 68.
IPoS The Hughes system is compliant with IPoS, ratified by the
Telecommunications Industry Association (TIA-1008), first
published in October 2003 and issued as Revision A in
May 2006.
FCC Part 68
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance -- This equipment (Two-Way Hughes
System: Model Numbers: HX50 and HX100) complies with Part
68 of the FCC rules and requirements adopted by the ACTA. On
the rear panel of this equipment is a label that contains, among
other information, the product part number (P/N) in the format
XXXXXXX-XXXX and an eight digit Electronic Serial Number
(ESN). If requested, this information must be provided to the
Telephone Company.
The Two-Way Hughes system needs to be installed according to
the instructions. Coaxial cables (Rx and Tx) need to be grounded
at the point of entry. A plug and jack used to connect this
equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant
26 Gauge telephone cord
Figure 76: IPoS symbol