Hughes HN9400, Installation Manual

Page: 45 / 134

Figure 19: Verifying the satellite parameters screen
3. Verify that the displayed information is correct and click Next .
If the parameters are not correct for the installation, click Back to change the satellite
transponder selection.
4. If you plan to use an antenna pointing tool, select
DAPT
,
OPI
, or
N/A
(for none) from the
Antenna Pointing Tool drop-down list.
For Ka-band select DAPT; for Ku-band a DAPT or OPI may be used.
5. Click Next .
Entering satellite parameters (manual entry)
This is an alternate method for entering the satellite parameters. You must use this method if
the satellite and transponder for your installation are not listed in the drop-down list in Figure
18: Satellite Parameters screen on page 32 and you were not provided with an
sbc.cfg
file.
Skip this section if you selected a satellite and transponder on the Satellite Parameters screen.
The satellite parameters are provided to you in a technical update email or in an installation
specification.
To enter the parameters:
1.
On the Satellite Parameters screen, select the
Enter satellite parameters manually
checkbox
shown in Figure 18: Satellite Parameters screen on page 32.
2. Click Next .
33
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 4 Commissioning the satellite router