Universal RF Receiver
1. Feature:
Before you begin, read all warnings and installation instructions and save for future use.
1/2
Model: H-R009PD
Universal RF receiver for multiple remotes
2. Product Dimension:
156mm (6.14”)
166mm (6.53”)
53.4mm (2.10”)
23mm (0.90”)
Ÿ
This product is intended to be installed and serviced by a qualied licensed electrician. Install in accordance with
the National Electric Code, and local regulations. Disconnect power before installing or servicing. Only power with
a regulated (listed) constant voltage Class 2 power supply (12-24V DC).
Ÿ
Ensure applicable wire is installed between driver, xture, and any controls in between. When choosing wire, factor
in voltage drop, amperage rating and type (in-wall rated, wet location rated, etc.). Inadequate wire installation
could overheat wires and cause re.
Ÿ
This product is rated for indoor installation and can be used for dry locations. Avoid the direct sun light.
Ÿ
Do not modify this product beyond the instructions in this guide or the warranty will be voided.
Ÿ
Wiring diagrams in this installation guide for basic installations. Please carefully review your installation before
proceeding.
Ÿ
Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
Ÿ
Please check if the output voltage of any LED power supplies used comply with the working voltage of the product.
Ÿ
Never connect any cables while power is on and always assure correct connections to avoid short circuits before
switching on.
Ÿ
Please ensure that the cable is secured tightly in the connector
Ÿ
For updated information please consult your supplier.
Safety & Warnings
HUEDA
™
LED | CALGARY, AB | CANADA
Copyright © 2016 HUEDA™ LED, A division of LED World Inc.. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
