Each Diamond Cutting Tool is specially manufactured under rigid
control and carefully inspected under microscope to guarantee
100% quality of each new tool.
If you follow these instructions, HUDY guarantees high-quality,
high-reliability armature cutting as well as a long life span for this
great tool.
We hope that you will be satisfied with the performance and
quality of this equipment. If you have any questions or advice
about how to improve this equipment, please do not hesitate to
contact us.
Thank you for choosing HUDY products!
Small regularly repeating grooves on the comm after a cut
The cutting tool is not held firmly, and it moves while you are cutting. Tighten
the two screws in the tool block that holds the cutting tool.
Cut comm does not have a mirror finish
A mirror finish is not as important as a smooth comm surface; the comm
must be smooth and even, as the entire burned layer must be cut down.
A mirror finish does not affect the quality of the cut nor the performance of
the motor.
Comm is coned after a cut
To achieve the best motor performance, the comm must have an even (non-
coned) surface. That is, the comm’s diameter at the both ends and the middle
must be the same. If the comm is cut conic, this means that the stands are
slightly out of alignment. This sometimes happens if you have replaced a stock
stand with the optional Axial Support, and that stand is not set properly.
Please refer to the instructions accompanying the stand to understand how
to set it properly.
HUDY, Pred Polom 762, 911 01 Trencin, Slovak Republic, Europe, tel.: ++421 32 7440 180, fax: ++421 32 7440 179
