12 | 36
OWNERS MANUAL | Cobolt Modulated DPSS Lasers | D0342-C JUNE 2016
Cables
In the CDRH compliance configurations delivered the standard cables listed below, using any other cable type or
length may violate CE compliance.
Laser Controller Cable
The laser controller cable is a 1m SubD26-SubD26 cable that connects the Laser Head to the Laser Controller. The
cable has a minimum bending radius 8 cm. When connected care should be taken not to bend or break any of the 26
pins.
RF Cable
The RF cable is a 0.2m SMA-SMA cable that connects the AOM to the AOM driver.
Digital Modulation Cable
The Digital modulation cable is a 0.2m BNC-subD cable connects the AOM driver to the digital modulation source.
The digital modulation source can be any source capable of delivering a TTL digital signal. For convenience a 5V power
supply is provided which can be used as a digital modulation source delivering a constant digital “on”. This can be
useful if only analogue modulation is of interest. See the set-up instruction below for more information.
Analogue Modulation Cable
The Analogue modulation cable is a 1m BNC-SMA cable that connects the AOM driver to the analogue modulation
source.
