Huber Pilot ONE Unistat T300 Series, Operation Manual

Page: 15 / 90

Introduction
Chapter 1 OPERATION MANUAL
V1.2.0en/12.05.15//14.06
Liability for errors and misprints excluded. Unistat® T300 Series
15
1.2.2 Proper operation
Operating the temperature control unit in a potentially explosive area
DEATH THROUGH EXPLOSION

Do NOT install or start up the temperature control unit within an ATEX zone.
Improper use
SERIOUS INJURY AND PROPERTY DAMAGE

Store the operation manual where it is easy to access in close proximity to the temperature
control unit.

Only adequately qualified operators may work with the temperature control unit.

Operators must be trained before handling the temperature control unit.

Check that the operators have read and understood the operation manual.

Define precise responsibilities of the operators.

Personal protective equipment must be provided to the operators.

Be sure to follow the responsible body’s safety rules to protect life and limb and to limit dam-
ages!
Modifications to the temperature control unit by third-parties
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Do not allow third parties to make technical modifications to the temperature control unit.

In case of any modification of the temperature control unit not approved by the manufacturer,
the CE declaration of conformity becomes invalid.

Only specialists trained by the manufacturer may carry out modifications, repairs or mainte-
nance work.

The following must be observed without fail:

Only use the temperature control unit in a fault-free condition!

Have start-up and repairs carried out only by specialists!

Do not ignore, bypass, dismantle or disconnect any safety devices!
The temperature control unit must not be used for any purposes other than temperature control in
accordance with the operation manual.
The temperature control unit is manufactured for industrial use. The temperature control unit main-
tains the temperature of certain applications, including glass or metal reactors or other expedient
items in laboratories and industry. Flow-through coolers and calibration baths must be used only in
combination with Huber temperature control units. Thermal fluids suitable for the overall system
are used. The chilling and heating capacity is provisioned at the pump connections or - where pre-
sent - in the tempering bath. The technical specification of the temperature control unit is given in
the data sheet (from page 89 in section »Annex« ). The temperature control unit must be installed,
configured and operated according to the handling instructions in this operating manual. Failure to
comply with the operation manual is deemed improper use. The temperature control unit conforms
to state-of-the-art technology and the recognized safety regulations. Safety devices are built into
your temperature control unit.