Function description
Chapter 3
OPERATION MANUAL
V2.4.0en/08.12.20//17.12
CC®-Immersion circulator
29
3
Function description
3.1
Function description of the temperature control unit
3.1.1
General functions
The CC heating circulators
are
temperature control units
ideally suited for the thermoregulation of baths.
This
controller generation
is characterized by the fact that there is only a
single hardware
. For a license
fee you will receive an
activation key
, which allows you to quickly expand the functionality of e.g. a simple
temperature control unit (basic version) to its
maximum functionality
(professional version) at any time.
Due to the powerful
heat technology,short heating times
can be achieved.
3.1.2
Other functions
Due to the
speed-controlled pressure and suction pump
, the mixing of the thermal fluid can be
optimally adapted to a given task.
The
self-optimizing cascade control
delivers
optimal controller results
for regulating levels up and
down. Temperature control can be either a-periodic or with a slight overshoot (faster).
Depending on the configuration level
both analog and digital interfaces, programmer and a Pt100
connection are available.
Your temperature control unit can be easily integrated into many laboratory automation systems. This is provid-
ed for by the existing
standard interfaces Ethernet, USB device and USB host at the “Pilot ONE”
. The optional
Com.G@te allows you to expand your temperature control unit by
digital interfaces (RS232 and RS485), an
analogue current loop interface (0/4 - 20 mA or 0 - 10 V) and various digital control options (In/Out)
.
The
removable control panel (“Pilot ONE”)
can also be used as a
remote control
. Please contact
your dealer or Huber Sales Department if you need an extension cable. The telephone number of
the Huber Sales Department can be found on page 72 in Section
.
A
connection jack for Pt100 process controller sensor
enables you to accomplish
external tempera-
ture control tasks
with ease (requires E-grade Exclusiv or Professional).
The temperature control unit can be retrofitted with an
integrated temperature ramp function
and
an
internal temperature programmer
via an “E-grade” upgrade. The “E-grade” upgrade
“Exclusiv”
enables you to set and call 3 temperature control programs with 5 program steps each by using the
integrated programmer. The “E-grade” upgrade
“Professional”
enables you to set and call 10 tem-
perature control programs with a total of 100 program steps by using the integrated programmer.
The temperature control unit has
overtemperature protection to DIN EN 61010-2-010, independ-
ent
of the control circuit itself.
3.2
Information on the thermal fluids
Non-compliance with the safety data sheet for the thermal fluid to be used
INJURIES
Risk of injury to the eyes, skin, respiratory tract.
The safety data sheet for the thermal fluid to be used must be read prior to using it and its
content must be respected.
Observe the local regulations/work instructions.
Wear your personal protective equipment (e.g. temperature-resistant safety gloves, safety
goggles, safety footwear).
Danger of slipping because floor and work area are contaminated. Clean the work station and
follow the instructions for the disposal of thermal fluid and material on page 15 in section
»Proper disposal of resources and consumables«
.
