The Path Pilot
®
KLV101/106
Installation Instructions
P.O. Box 60080
•
16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-56
66 • FAX
626/330-3861
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS: Do not overdrive fixtures with greater
than 12 volts or fixture over-heating and short lamp life will occur. Do not overload the transformer by
installing (or relamping) higher wattage lamps than planned. Note: Total wattage of all lamps connected to one
transformer must not exceed the capacity of that transformer. Do not install luminaire within 10 feet (3.04 m) of
a pool, spa or fountain.
SAFETY WARNING: When relamping, be sure electrical supply is OFF. Lighted lamp is HOT! Low voltage
fixtures can become very hot depending on the lamp wattage used. Glass lenses and metal areas above
& around the lamp can become hot enough to blister hands. Use discretion when touching fixture and be sure
to allow fixture to cool before relamping. When relamping fixture avoid touching the lamp envelope with bare
hands. If touching the lamp is necessary during installation, clean the envelope with alcohol and dry with a
clean, soft cloth before turning ON. Contamination of the envelope may reduce lamp performance. Particular
care should be taken not to locate fixtures where small children can reach them if higher wattages are used.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.
NOT INTENDED FOR INDOOR USE. All electrical work should be done by a qualified electrician.
KEEP THIS SHEET FOR FUTURE REFERENCE.
Revised 7/
16
/10 ECN 100715008 Status 15 Part No. 95477
Tools Required
:
Flat Head Screwdriver
Silicone Grease
!
t
a
lf
r
u
o
f
e
v
o
m
e
r
,
p
m
a
l
ll
a
t
s
n
i
o
T
.
3
.
d
a
e
h
e
r
u
t
x
if
o
t
m
e
t
s
e
r
u
t
x
if
h
c
a
tt
A
.
1
head screws from bottom of husk.
4a.
KLV106 only -
Remove top cap, louvers
and globe.
Make certain electrical supply is
OFF
before starting fixture installation.
2. Attach complete assembly to de-
sired mounting.
Note:
KLV
Mounting Options can be installed
before fixture is attached.
Stem
Fixture
Head
Fixture Wire
Fixture Stem
Spear Mount
Fixture
Wire
Flat Blade
Screwdriver
Louvers
Top Cap
Globe
Screws
KLV106
KLV101
!
4b.
KLV101 only -
Remove top cap and globe.
Top Cap
Screws
Globe
!