SCARAB
™
Accent Series - KLV710 / KLV715
Installation Instructions
P.O. Box 60080
•
16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666
•
FAX 626/330-3861
Revision
10/14/11
EC 111014007
Status 10
Part No. 95588
Tools Required:
Phillips Screwdriver
B
” Hex Wrench
Flatblade Screwdriver
Adjustable Wrench
Silicone Grease
Fixture Cable
Shield
Gasket
Lens
1. Tighten coupling onto
mounting device. (Consult
Kim Landscape Catalog for
mounting device options.)
2. Install fixture onto coupling.
Note
: Kim "KLV" Mounting
Options can be installed
before fixture is installed.
3. Remove lens and shield. Install lamp of type
and wattage shown on fixture label and chart
below. Do not exceed maximum wattage. Coat
screws with silicone grease.
INSTALLATION INSTRUCTIONS:
Make certain the electrical supply is
OFF
before starting installation.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS: Do not overdrive fixtures with greater
than 12 volts or fixture over-heating and short lamp life will occur. Do not overload the transformer by
installing (or relamping) higher wattage lamps than planned. Note: Total wattage of all lamps connected to one
transformer must not exceed the capacity of that transformer. Do not install luminaire within 10 feet (3.04m) of
a pool, spa or fountain.
SAFETY WARNING: When relamping, be sure electrical supply is OFF. Low voltage fixtures can
become very HOT depending on the lamp wattage used. Glass lenses and metal areas above & around
the lamp can become HOT enough to blister hands. Lamp gets HOT quickly! Contact only switch/plug when
turning on. Use discretion when touching fixture and be sure to allow fixture to cool before relamping. When
relamping fixture avoid touching the lamp envelope with bare hands. If touching the lamp is necessary during
installation, clean the envelope with alcohol and dry with a clean, soft cloth before turning ON. Contamination
of the envelope may reduce lamp performance. Particular care should be taken not to locate fixtures where
small children can reach them if higher wattages are used.
NOT INTENDED FOR INDOOR USE.
MAINTENANCE: To maintain light efficiency and prevent fixture-overheating, glass lenses and enclosure must
be kept clean and free of dirt, dust, leaves, trash (combustible materials) and mineral deposits from water.
DO NOT operate luminaire with missing or damaged lens.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.
All electrical work should be done by a qualified electrician. KEEP THIS SHEET FOR FUTURE REFERENCE.
!
!
KLV710
KLV715
!
Unit intended for mounting with Diffuser/Glass Barrier and Lamp Holder greater than 2 in. (5.08 cm)
from the ground plane.