Revised 06/26/12 EC 120626005 Status 14
Part No. 95268
B30 Series 8
"
Round Traditional Bollard
Installation & Maintenance Instructions
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
Failure to do so may result in serious personal injury.
MAINTENANCE WARNING: To maintain light efficiency and prevent fixture overheating, reflector and lens must
be kept clean and free of dirt, dust, leaves, and trash. For optimum performance a regularly scheduled
maintenance program should be followed.
CAUTION: All wiring must be done by a qualified electrician. KEEP THIS SHEET FOR FUTURE REFERENCE.
B30
8
"
Round
T
op Cover/
Lens Assembly
Reflector
Assembly
Socket/Base
Assembly
Riser
(Pole Body)
Base/Ballast
Bracket Assembly
Base Casting / Ballast Assembly Installation:
Make certain the electrical supply is
OFF
before starting installation.
1. Install the base casting/ballast assembly on the pre-set anchor bolts. Use flat washers
and hex nuts both below and above the base casting.
2. Level the top edge of the casting by adjusting the bottom leveling nuts. Tighten the
upper nuts.
3. Connect the circuit ground wire to the grounding lug on the ballast bracket.
4. Connect power supply leads to the ballast input leads. See diagram below.
NOTE:
For incandescent fixtures, connect the power supply leads directly to the lamp leads -
no ballast required
.
ATTENTION:
If your fixture is equipped with a multi-tap ballast and if no voltage was specified on the purchase order,
the ballast has been wired for operation on a 277 volt circuit (347v in Canada). If other than 277 volts is required, i.e.
120v, 208v, 240v, connect incoming voltage lead to selected voltage lead on ballast. Cap off all unused voltage leads.
Tools Required:
Ratchet with
N
" Deep Socket
F
" Hex Key
B
" Hex Key
N
" Open-end Wrench
Flat Blade Screwdriver
Fixture Installation:
Make certain the electrical supply is
OFF
before starting
fixture installation.
1. To protect finish, lay fixture horizontally on soft cloth with open-
end of fixture next to installed base casting/ballast assembly.
2. Connect fixture ground lead (green) to the short green wire con-
nected to the grounding lug on the ballast bracket.
3. Connect the lamp leads to the ballast.
NOTE:
For incandescent
fixtures, connect the power supply leads directly to the lamp leads.
4. Place pole body over ballast assembly and slowly turn until body
drops into retaining slots, then twist clockwise to lock the pole onto
the base casting.
5. Tighten the two set screws at the bottom of the pole using a
F
”
hex key.
LEVEL
3" Max.
Grade
Base Casting/ Ballast Assembly
Fixture Installation
Conduit
(by others)
Anchor Bolt (4)
Concrete
In Concrete Pad
(Leveling)
Nut and
Washer (4)
Nut and
Washer (4)
Riser/
Pole Body
Base Casting/
Ballast Assembly
In Earth
(grade slopes away)
Final Installation Detail
!
!
!
