H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH
•
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
30801
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note:
This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a non-
wood frame application, we recommend consulting a qualified builder
or electrician.
To Mount Fixture to Wall
(Figures 1 & 2)
Component Parts
A Fixture Assembly
B Mounting Bracket
C Anchors (4)
D #10 Screws (4)
E #8 Screws (4)
F Ground Screw
G Cupped Washer
H Rubber Washers (2)
I Caulking Lip
CAUTION:
BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
mounting bracket (B) to the electrical box.
Note:
A new electrical box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. If mounting bracket (B) can’t be mounted to the electrical
box, follow steps 4 through 6 to attach mounting bracket to
the wall using anchors (C).
4. Center the mounting bracket (B) over the electrical box
being sure to hold it plumb and level. With a pencil, mark
the location of all mounting holes in the mounting bracket on
the wall behind.
5. Put the mounting bracket (B) down and drill 1/4" holes in the
locations marked on the wall. For holes using anchors (C),
place the tapered end of the anchors (C) into the holes and
gently tap them flush to the wall using a light weight hammer.
cupped washer (G) to the electrical box and connect
all ground wires (bare copper or green to bare copper or
green).
B320
Elton Outdoor Sconce 303050, 303053 & 303055
Page 1 of 3
CAUTION:
FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE.
We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
(Figure 2)
I
G
C
F
B
H
D
A
E
