Installation Instructions
B179
For Beacon Hall Outdoor Wall Sconce 30-4820 & 30-4820F
Page 1 of 3
Hand-Forged,
Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22746
Please Note:
After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install Fixture
(Figures 1 & 2)
Component Parts
A Crossbar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking
Lip
Caution: Be sure power is off at the main breaker
box prior to installation.
1.
Carefully unpack the fixture from the carton.
2.
Using two machine screws (not provided)
attach cross bar (A) to the electric box using
inside oval holes to orient fixture.
Note:
A new electric box comes with screws.
When replacing a fixture, retain the screws
for use with the new fixture.
3.
Start threaded studs (B) into appropriate holes
in crossbar (A).
4.
Using suitable wire connectors (not provided), connect the fixture
wires to the supply wires, (white to white, black to black, bare copper
or green to bare copper or green). If the fixture is wired with twin lead
lamp cord, connect the ribbed side to white, and the smooth side to
black.
Caution:
Make sure wire connectors are twisted on securely
and no bare wires are exposed.
5.
Apply a generous bead of a suitable caulking material to caulking lip
(E) on the fixture.
6.
Carefully tuck all wires behind the fixture. Place fixture (C) over
threaded studs (B) and tighten firmly to mounting surface using barrel
knobs (D).
(continued)
CAUTION:
FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution:
Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)
