1.
Run:
system-view
The system view is displayed.
2.
Run:
poe power-reserved
reserved-power-percent
[
slot
slot-id
]
The percentage of the reserved PoE power against the total PoE power is set.
By default, 20% of the total PoE power is reserved.
l
(Optional) Setting the alarm threshold of power consumption percentage
1.
Run:
system-view
The system view is displayed.
2.
Run:
poe power-threshold
thresholdvalue
[
slot
slot-id
]
The alarm threshold of power consumption percentage is set.
By default, the alarm threshold is 90%. That is, an alarm is generated when the
consumed power accounts for 90% of the total power.
----End
8.3.3 Configuring the PoE Function on an Interface
In an interface view, you can enable the PoE function, set the maximum output power, set the
power supply priority, and specify the power-off time segment.
Procedure
Step 1
Enable the PoE function on an interface.
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
The interface view is displayed.
3.
Run:
poe enable
The PoE function is enabled.
By default, the PoE function is enabled on all interfaces.
Step 2
Optional:
Set the maximum output power of an interface.
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management
8 PoE Configuration
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
115
