Copyright © Huawei Technologies Co., Ltd. 2015. All rights reserved.
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
HUAWEI USG6310/6320 Uni
fi
ed Security Gateway
V100R001
Quick Start
Issue: 04
Part Number: 31507267
Date: 2015-06-18
1
Thank you for using Huawei USG6310/6320 products. This USG product series protects your network against Internet
threats. This Quick Start shows the product appearance and provides the essential information required for installing the
device and setting up Internet access. For detailed hardware description and installation guidelines, refer to the
Hardware
Guide
. For detailed con
fi
gurations, refer to the
Administrator Guide
.
Safety Precautions
Be aware of the following safety precautions when installing the device.
• Deactivate power whenever possible before performing maintenance on power cables.
• Always wear a properly-grounded wrist strap before touching the device or expansion cards in it.
Device and Accessories
Your product package includes the following items:
PWR SYS ALM USB
Secospace USG6000
1
3
5
7
0
2
ETH
4
6
Secospace USG6000
0
2
4
6
1
3
5
7
RST
12V ; 3A
CONSOLE
XXXXXXXXXXXXXXXXXXXXXXXXXXX
Console port
Protection ground
terminal
Power
PGND cable
Power Cable
retention clip
Quick start
M4 screw
M6 screw
Rack-mounting ears
AC power cable 36W power adapter
Reset button
USB
Port indicators
Indicators
Rubber feet
Equipment
Serial Number
10/100/1000M autosensing
Ethernet electrical interface
•
The rack-mounting ear is optional.
•
AC power cables vary by country or area, and the AC power cable in the figure is used for reference only.
Cabling
1. Connect the ground terminal on the device to the ground bar using a PGND cable.
2. Connect the device to the WAN and LAN through Ethernet ports (GE0/0/4 and GE0/0/6 in this example, respectively).
3. Connect the device' interface GE0/0/0 to a PC where the NMS client is installed using a network cable.
4. Insert the cable retention clip into the hole close to the power socket. Connect the AC power cable to power adapter, and
insert the 4-pin self-locking plug of the power adapter into the power socket on the device. Then round the clip over the
power cable and
fi
x it using the clip. Insert the AC power cable plug into the power supply socket.
As
USG
does not provide a power switch, it starts up immediately after receiving power. When the SYS indicator
on the SPUA panel is blinking (once every two seconds), the device is running and ready for configuration.
