●
The optical module has been installed.
Procedure
Step 1 Insert an optical transceiver into the 10GE, or 40GE, or 100GE optical port of the
USG.
Step 2 Remove the dust cap from the optical transceiver.
NO TE
Set aside the dust cap properly for future use. After optical fiber are disconnected for
maintenance, use the dust cap to prevent the optical transceiver from dust.
Step 3 Before connecting an optical fiber, attach temporary labels to both ends of the
optical fiber for identification.
Step 4 Remove protective caps from optical fiber connectors, insert optical fibers into the
optical transceiver, and connect the fiber to the peer device.
NO TE
Ensure that the Tx and Rx ports are correctly connected.
Ensure that the TX and RX ports on one end of the optical fiber cable are
connected to the RX and TX ports (respectively) on the other end.
HUAWEI USG6000E Series
Hardware Guide
5 Hardware Installation
Issue 08 (2022-04-20)
Copyright © Huawei Technologies Co., Ltd.
574
