NO TE
● The Stop Upgrade function applies only to the devices waiting to be upgraded.
● If the active power control mode is set to Grid connection with limited power or Remote
communication scheduling, and the reactive power control mode is set to Power factor
closed-loop control or the working mode of Battery Control is enabled, you are advised to
upgrade software when inverters and Smart PCSs are disconnected from the grid. Otherwise,
power control may be abnormal or the upgrade may fail.
----End
7.4.2 Setting Security Parameters
Figure 7-2 Security settings
Parameter
Description
Change Password
Change the password for the current login user to log
in to the WebUI.
Automatic logout time
After this parameter is set, a user is automatically
logged out if the user does not perform any operation
within the period specified by this parameter.
WebUI Security
Certificate
You are advised to use the existing network security
certificate and key.
Update Key
Update the key for saving the password.
SmartModule Security
Certificate
Load the network security certificate of the
SmartModule.
If the private key file has a password, select Enable
key password and enter the key password obtained
from the certificate provider.
SmartModule
Communication Setting
Specifies whether to enable communication using an
expired certificate.
If this parameter is set to Enable, the SmartLogger
can communicate with the SmartModule. After the
certificate expires, set this parameter to Disable to
prevent the SmartLogger from communicating with
the SmartModule to ensure network security.
WEB TLS Setting
[1]
Enables or disables the TLS1.0 and 1.1 function.
SmartLogger3000
User Manual
7 Device Maintenance
Issue 10 (2022-08-20)
Copyright © Huawei Technologies Co., Ltd.
243