SmartLogger1000
User Manual
7 WebUI
Issue 12 (2019-01-15)
Copyright © Huawei Technologies Co., Ltd.
226
Mode for the SmartLogger to connect to the IEC103 device: When the SmartLogger connects
to the NMS, it transparently transmits IEC103 device information to the NMS.
Because of permission restriction, log in as
Advanced User
. Choose
Settings
>
IEC103
to
access the target page.
Figure 7-50
Setting IEC103 parameters
Third-party devices and Huawei devices must be connected to different ports of the SmartLogger.
Otherwise, the communication will be abnormal.
The value of
IEC103 IP
must be consistent with the IP address of the NMS.
7.10.2.7 Setting IEC104 Parameters
IEC104 is a general standard protocol without a security authentication mechanism. To reduce
network security risks, connection to a third-party NMS over the IEC104 protocol is disabled
by default. The SmartLogger can connect to a maximum of five third-party NMSs.
If the SmartLogger connects to a third-party NMS over the IEC104 protocol, IEC104
parameters must be correctly set to enable the third-party NMS to monitor the running status
of devices connected to the SmartLogger.
Because of permission restriction, log in as
Advanced User
. Choose
Settings
>
IEC104
to
access the target page.