CAUTION
When adding a user, you can configure the phone number (parameter
telno
). When the
public ID is generated by phone number, you must enter the phone number. It is
recommended that you configure this phone number to be the same as the phone number
configured on the IMS. In addition, ensure that the phone number is unique on the AG.
3.
Run the
display sippstnuser
command to check whether the PSTN user data is the same
as the planned data.
Step 3
(Optional) Configure the attributes of a PSTN user.
The attributes of a PSTN user need to be configured when the default settings are inconsistent
with the actual application.
1.
Run the
sippstnuser attribute set
or
sippstnuser attribute batset
command to configure
the attributes of a PSTN user.
2.
Run the
display sippstnuser attribute
command to check whether the attributes of the
PSTN user are the same as the planned data.
----End
Example
Assume that the phone numbers of 32 PSTN users are 83120000-83120031 and the default
values are used for other attributes. To add the PSTN users in slot 0/3 on SIP interface 0 in
batches, do as follows:
huawei(config)#
esl user
huawei(config-esl-user)#
sippstnuser batadd 0/3/0 0/3/31 0 telno 83120000 step 1
huawei(config-esl-user)#
display sippstnuser 0/3
---------------------------------------
F /S /P MGID TelNo
---------------------------------------
0 /3 /0 0 83120000
......
0 /3 /30 0 83120030
0 /3 /31 0 83120031
---------------------------------------
7.2.2.2 Configuring the Centrex
Centrex refers to a virtual user group. The MA5616 supports the following functions: Members
in a centrex can call each other by dialing short numbers, and members in a centrex can call the
members outside of the centrex by dialing centrex the complete phone number.
Context
l
The function that the members in a centrex can call each other by dialing short numbers
need not be configured on the MA5616 through the command line interface (CLI).
l
The function that the members in a centrex can call the members outside of the centrex by
dialing centrex the complete phone number can be supported only when the SIP
protocol is used.
l
The centrex attribute of a centrex can be direct centrex or two-stage centrex. The similarity
and difference are as follows:
SmartAX MA5616 Multi-service Access Module
Configuration Guide
7 Configuring the Voice Service
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
254
