F/S/P : 0/1/0
ONT-ID : 1
Control flag :
active
//Indicates that the ONT is
activated.
Run state :
online
//Indicates that the ONT goes online
successfully.
Config state :
normal
//Indicates that the configuration state of the
ONT is normal.
Match state :
match
//Indicates that the capability profile bound to
the ONT is consistent with the actual capability of the ONT.
...//The rest of the response information is omitted.
When
Config state
is
failed
,
Run state
is
offline
, or
Match state
is
mismatch
:
l
If
Control flag
is
deactive
, run the
ont active
command in GPON mode to activate the ONU.
l
If
Run state
is
offline
, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
l
If
Config state
is
failed
, the configured ONU capability exceeds the actual ONU capability.
In this case, run the
display ont failed-configuration
command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
l
If the ONU does not match, that is,
Match state
is
mismatch
, the port types and number of
ports undermatch the actual port types and number of ports supported by the ONU. In this
case, run the
display ont capability
command to query the actual capability of the ONU,
and then select one of the following modes to modify the ONU configuration:
–
Create a proper ONU profile according to the actual capability of the ONU, and then run
the
ont modify
command to modify the configuration data of the ONU.
–
Modify the ONU profile according to the actual capability of the ONU and save the
modification. Then, the ONU automatically recovers the configuration successfully.
----End
9.7.2.4 Configuring the Internet Access Service
The OLT is connected to the remote ONT through a GPON port to provide users with high-
speed Internet access services.
Prerequisites
l
The OLT is connected to the BRAS.
l
Related configurations are performed on the BRAS according to the authentication and
accounting requirements for dialup users. For details about the configuration, see the
configuration guide.
l
The ONT has been added to the OLT. For details, see
l
The VLAN of the LAN switch port connected to the OLT is consistent with the upstream
VLAN of the OLT.
l
Residential users generally access the Internet in Point-to-Point Protocol over Ethernet
(PPPoE) dial-up mode. PPPoE dial-up can be performed on personal computers (PCs) or
HGWs.
l
The configuration processes on HGWs of different models or in different appearances are
similar. This topic describes how to configure the Internet access service on an HG239 that
is connected to an ONT upstream through a LAN.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
635