Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
snmp-agent group
v3
group-name
[
authentication
|
privacy
] [
read-view
read-view
|
write-view
write-view
|
notify-view
notify-view
]
*
[
acl
acl-number
]
Read/write authority of the user group is configured.
----End
1.13.5 Configuring User Information
NM Station user information configured on the NM Station and the device must be identical.
Otherwise, the NM Station cannot access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
snmp-agent usm-user
v3 user-name
group-name
Users are added into the SNMPv3 user group.
----End
1.13.6 Checking the Configuration
After MIB-view-based access control in SNMPv3 is configured, you can view configurations
of the MIB and users.
Prerequisite
The configurations of the MIB-View-based Access Control in SNMPv3 are complete.
Procedure
l
Run the
display snmp-agent group
[
group-name
] command to view information about
the SNMP group.
l
Run the
display snmp-agent mib-view
command to view the information on the MIB view
l
Run the
display snmp-agent usm-user
[
engineid
engineid
|
group
group-name
|
username
user-name
] * command to view information about users in the SNMP group.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1 SNMP Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-43
