7.5.5 Configuring the Aggregation Function
7.5.6 Checking the Configuration
7.5.1 Establishing the Configuration Task
Applicable Environment
When the NetStream function is configured in the IPv4 network, a mode of collecting statistics
about aggregation traffic must be configured to classify statistics about packets according to
certain rules.
Pre-configuration Tasks
Before configuring NetStream for aggregation traffic, complete the following tasks:
l
Setting physical parameters on an interface
l
Setting the link-layer parameters of the interface
Data Preparation
To complete the configuration, you need the following data.
No.
Data
1
Name and number of the interface on which
traffic statistics need to be collected
2
Version number of exported packets of the
NetStream traffic statistics
3
IP addresses and port numbers of the NSC
7.5.2 Configuring the NetStream Function on an Interface
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
interface
{
ethernet
|
gigabitethernet
|
xgigabitethernet
}
interface-number
The interface view is displayed.
Step 3
Run:
ip netstream
{
inbound
|
outbound
}
The NetStream function is enabled on the interface to collect statistics about IPv4 unicast traffic.
By default, the NetStream function is disabled in inbound and outbound directions.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
7 NetStream Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7-13
