Huawei Quidway S9300, Configuration Manual - Network Management

Page: 419 / 630

#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 150
port hybrid untagged vlan 150
#
interface GigabitEthernet3/0/0
port hybrid pvid vlan 130
port hybrid untagged vlan 130
#
ospf 1
area 0.0.0.0
network 11.1.0.0 0.0.0.255
network 11.1.1.0 0.0.0.255
network 11.1.2.0 0.0.0.255
#
pim
#
return
6.37.21 Example for Checking the Multicast Path from the Source to
Destination Host Through the MTrace Test
Networking Requirements
As shown in Figure 6-23 , on the PIM-SM multicast network, implement the NTP protocal on
all Switches to make Switches work synchronously, Receiver is added to the multicast group
225.1.1.1 and receives multicast data from Source normally. This test is performed to check how
the multicast traffic is transmitted to Receiver from Source.
You can configure an NQA MTrace test on Switch C to implement the MTrace function. You
can check the multicast path from the multicast source to the destination host.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-199