Huawei Quidway S9300, Configuration Manual - Network Management

Page: 403 / 630

area 0.0.0.0
network 10.1.1.0 0.0.0.255
#
nqa test-instance admin pathjitter
test-type pathjitter
destination-address ipv4 11.1.1.2
icmp-jitter-mode icmp-echo
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 100 110
#
interface Vlanif100
ip address 10.1.1.2 255.255.255.0
#
interface Vlanif110
ip address 11.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ospf 11
area 0.0.0.0
network 10.1.1.0 0.0.0.255
network 11.1.1.0 0.0.0.255
#
return
l Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 11.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ospf 1
area 0.0.0.0
network 11.1.1.0 0.0.0.255
#
return
6.37.18 Example for Checking the RPF Path from the Source to the
switch Through the MTrace Test
Networking Requirements
As shown in Figure 6-20 , on the PIM-SM multicast network, implement the NTP protocal on
all Switches to make Switches work synchronously, receiver is added to the multicast group
225.1.1.1 and receives multicast data from Source normally. This test is performed to check how
the traffic is transmitted to the RTB from Source along the RPF route.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-183