start
now
The NQA MTrace test is started.
Step 4
Run:
quit
Exit from the test instance view.
----End
6.21.6 Checking the Configuration
After performing the MTrace test for the RPF path from the multicast source to the querier, you
can view the test result.
Prerequisite
The configurations of the NQA MTrace Test function are complete.
Context
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the
display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Procedure
l
Run the
display nqa-agent
[
admin-name
test-name
] [
verbose
] to view the status of the
test instance configured on the NQA client.
l
Run the
display nqa results
command to view the test results on the NQA client.
l
Run the
display nqa history
command to view the history of the NQA test.
l
Run the
display mtrace statistics
command to view the statistics of the MTrace packets.
----End
Example
Run the
display nqa-agent
command. If information about the NQA test is displayed, it means
that the test is successful. For example:
<Quidway>
display nqa-agent admin aa verbose
nqa test-instance aa aa
test-type mtrace
mtrace-source-address ipv4 11.1.1.2
nqa status : normal
6.22 Configuring the NQA MTrace Test to Check the
Multicast Path from the Multicast Source to the Querier
This section describes how to configure an MTrace test to check the multicast path from the
multicast source to the querier.
6.22.1 Establishing the Configuration Task
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-76
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
