No.
Data
4
(Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
5
Start mode and end mode of the test
6.13.2 Configuring the UDP Server
The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (UDP server):
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
nqa-server udpecho
[
vpn-instance
vpn-instance-name
]
ip-address
port-number
The UDP monitoring service is configured.
Note that the IP address and port number monitored by the server should be consistent with those
configured on the client.
----End
6.13.3 Configuring the UDP Client
This part describes how to set UDP test parameters.
Context
Do as follows on the NQA client (UDP client):
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
An NQA test instance is created and the test instance view is displayed.
Step 3
Run:
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-35
