![Huawei Quidway S9300 Configuration Manual - Network Management Download Page 244](http://html.mh-extra.com/html/huawei/quidway-s9300/quidway-s9300_configuration-manual-network-management_169487244.webp)
The test instance is started after a certain delay.
----End
6.9.3 Checking the Configuration
After configuring the DNS test, you can view the test result.
Prerequisite
The configurations of the DNS Test function are complete.
Context
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the
display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Procedure
Step 1
Run the
display nqa results
[
test-instance
admin-name
test-name
] command to view the test
results on the NQA client.
----End
Example
Run the
display nqa results
command. If the test is successful, the following is displayed.
<Quidway>
display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is dns
1 . Test 1 result The test is finished
Send operation times: 1 Receive response times: 1
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:10.82.55.191
Min/Max/Average Completion Time: 4/4/4
Sum/Square-Sum Completion Time: 4/16
Last Good Probe Time: 2010-06-21 15:40:12.6
Lost packet ratio: 0 %
6.10 Configuring the Traceroute Test
This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.10.1 Establishing the Configuration Task
6.10.2 Configuring Traceroute Test Parameters
This part describes how to set traceroute test parameters.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)