Command Manual – Port
Quidway S8500 Series Routing Switches
Chapter 2 Ethernet Link Aggregation Configuration
Commands
Huawei Technologies Proprietary
2-12
[Quidway] link-aggregation group 22 description myal1
2.1.14 link-aggregation group agg-id mode
Syntax
link-aggregation group
agg-id
mode
{
manual
|
static
}
undo link-aggregation group
agg-id
View
System view
Parameter
agg-id
: Aggregation group ID, in the range of 1 to 920. IDs 1 though 31 indicate manual
or static aggregation groups; IDs 32 through 64 are reserved; IDs 65 though 192
indicate Routed Trunks; IDs 193 through 920 indicate dynamic aggregation groups.
Description
Use the
link-aggregation group agg-id mode
command to create an aggregation
group.
Use the
undo link-aggregation group
command to delete an aggregation group.
Related command:
display link-aggregation summary
.
Note:
Port aggregation includes manual aggregation, static aggregation and dynamic
aggregation.
z
In the manual aggregation mode, ports working at different rates can be aggregated.
Manual aggregation can be load balancing aggregation if the aggregation resource
is available. In this case, if the traffic rate shared by a low-rate port exceeds the
maximum rate of the port, packets may be lost.
z
In the static aggregation mode, ports working at different rates can also be
aggregated. However, the Selected/Standby state of statically aggregated ports is
determined by the transmission rate. Only the ports with the maximum rate and in
full-duplex mode can be selected to forward traffic, while other standby ports do not
forward traffic.
Example
# Create manual aggregation group 22.
<Quidway> system-view
