Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Huawei Technologies Proprietary
1-22
1.3.7 Cutting Down User Connections Forcibly
Table 1-11
Cut down user connection forcibly
Operation
Command
Description
Enter system view
system-view
—
Cut down user
connections forcibly
cut connection
{
all
|
access-type
{
dot1x
|
mac-authentication
} |
domain
isp-name
|
interface
interface-type interface-number
|
ip
ip-address
|
mac mac-address
|
radius-scheme
radius-scheme-name
|
vlan
vlan-id
|
ucibindex ucib-index
|
user-name user-name
}
Required
Note:
Telnet and FTP users can use the
display connection
command to view the
connection, but they cannot use the
cut connection
command to cut down the
connection.
1.4 RADIUS Configuration
The RADIUS protocol configuration is performed on a RADIUS scheme basis. In an
actual network environment, you can either use a single RADIUS server or two
RADIUS servers (primary and secondary servers with the same configuration but
different IP addresses) in a RADIUS scheme. After creating a new RADIUS scheme,
you should configure the IP address and UDP port number of each RADIUS server you
want to use in this scheme. These RADIUS servers fall into two types:
authentication/authorization, and accounting. And for each kind of server, you can
configure two servers in a RADIUS scheme: primary server and secondary server. A
RADIUS scheme has the following attributes: IP addresses of the primary and
secondary servers, shared keys, and types of the RADIUS servers.
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server, and at the same time, you should keep the RADIUS service port
settings on the switch consistent with those on the RADIUS servers.
