Operation Manual – Port Basic Configuration
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 1 Port Basic Configuration
Huawei Technologies Proprietary
1-4
An access port can only be added to one VLAN, while hybrid and trunk ports can be
added to multiple VLANs.
Note:
The access ports or hybrid ports must be added to an existing VLAN.
1.2 Ethernet Port Configuration
1.2.1 Initially Configuring a Port
Table 1-4
Initially configure a port
Operation
Command
Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the Ethernet
port
undo shutdown
Optional
By default, the port is
enabled.
Use the
shutdown
command to disable the port.
Set the description of
the Ethernet port
description
text
Optional
By default, no description is
defined for the port.
Set the duplex mode of
the Ethernet port
duplex
{
auto
|
full
|
half
}
Optional
By default, the duplex mode
of the port is
auto
(auto-negotiation).
Set the speed of the
Ethernet port
speed
{
speed-value
|
auto
}
Optional
By default, the speed of the
port is
auto
(auto-negotiation).
Set the medium
dependent interface
(MDI) attribute of the
Ethernet port
mdi
{
across
|
auto
|
normal
}
Optional
Be default, the MDI attribute
of the port is
auto
.
Allow jumbo frames
that are not larger than
9216 bytes to pass
through the Ethernet
port
jumboframe enable
Optional
By default, jumbo frames that
are not larger than 9216
bytes are allowed to pass
through the port.
