Operation Manual – Port
Quidway S3100 Series Ethernet Switches
Chapter 1 Basic Port Configuration
Huawei Technologies Proprietary
1-7
1.2.6 Configuring Trunk Port Attribute
Table 1-8
Configure trunk port attribute
Operation
Command
Remarks
Enter system view
System-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the link type for the
port as trunk
port link-type
trunk
Required
Set the default VLAN ID
for the trunk port
port trunk pvid vlan
vlan-id
Optional
By default, the VLAN of a
trunk port is VLAN 1.
Add the current trunk
port into the specified
VLAN
port trunk permit vlan
{
vlan-id-list
|
all
}
Optional
1.2.7 Copying Port Configuration to Other Ports
To keep the configuration of some other ports consistent with a specified port, you can
copy the configuration of the specified port to these ports.
The configuration may include:
z
VLAN settings: Includes the permitted VLAN types and default VLAN ID.
z
QoS settings: Includes traffic limiting, priority marking and default 802.1p priority.
z
STP settings: Includes STP enabling/disabling, link attribute (point-to-point or not),
STP priority, path cost, maximum transmission speed, loop protection, root
protection, and edge port or not.
z
Port setting: Includes port link type, port speed, and duplex mode.
Table 1-9
Copy port configuration to other ports
Operation
Command
Remarks
Enter system view
system-view
—
Copy port
configuration to
other ports
copy configuration source
{
interface-type
interface-number
|
aggregation-group
source-agg-id
}
destination
{
interface-list
[
aggregation-group
destination-agg-id
] |
aggregation-group
destination-agg-id
}
Optional
