![Huawei NetEngine5000E Configuration Manual Download Page 82](http://html.mh-extra.com/html/huawei/netengine5000e/netengine5000e_configuration-manual_169429082.webp)
<HUAWEI>
display snmp-agent inform
Global config: resend-times 3, timeout 15s, pending 39
Global status: current notification count 0
Target-host ID: Host name/VPN instance/IP-Address/Security name
targetHost_1_36305/-/1.2.1.2/public:
Config: resend-times 3, timeout 15s
Status: retries 0, pending 0, sent 0, dropped 0, failed 0, confirmed 0
Run the
display current-configuration
command to view VACM groups.
<HUAWEI>
display snmp-agent vacmgroup
--------------------------------------------------
Security name : public
Group name : public
Security model : SNMPv1
Security name : public
Group name : public
Security model : SNMPv2c
--------------------------------------------------
3.4 Configuring a Device to Communicate with an NM
Station by Running SNMPv3
After SNMPv3 is configured, a managed device and an NM station can run SNMPv3 to
communicate with each other. To ensure communication, you need to configure the agent and
NM station. This section describes the configuration on a managed device (the agent side). For
details about configurations on an NM station, see the NMS operation guide.
Applicable Environment
The NM station manages a device by the following ways:
l
Sends requests to the managed device to perform the GetRequest, GetNextRequest,
GetResponse, GetBulk, or SetRequest operation, obtaining data or setting values.
l
Receives alarms (traps or informs) from the managed device to locate and handle device
faults based on the alarm information.
Pre-configuration Tasks
Before configuring a device to communicate with an NM station by running SNMPv3, configure
a routing protocol to ensure that at least one route exist between router and NM station.
HUAWEI NetEngine5000E Core Router
Configuration Guide - System Management
3 SNMP Configuration
Issue 01 (2011-10-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
74