iBattery 3.0
User Manual
5 System Commissioning
Issue 07 (2019-12-30)
Copyright © Huawei Technologies Co., Ltd.
59
Step 7
Hold down all iBOXs networking switch for 2 seconds. The ALM indicator blinks red once,
and the RF_Z indicator turns from steady green to blinking green at super short intervals,
which indicates that the iBOX is being networked.
Step 8
Hold down all iBATs networking switch for 2 seconds. When the RUN/ALM indicator turns
from steady red to blinking green at short intervals, and finally to blinking green at long
intervals, the iBAT connects to the iBOX network.
Step 9
After all iBATs are successfully connected in the parallel network, when the RF_Z indicator
on the iBOX turns from blinking green at super short intervals to blinking green at long
intervals, the networking is complete.
----End
5.6 iBAT Networking Configuration
Context
The networking is complete. For details, see
5.5 Networking the iBOX and iBAT
If some iBATs need to be adjusted after the networking, refer to the following
configuration method.
To meet the requirement that the number can be adjusted freely, the iBOX will assign a
number (1–300) to each iBAT that requests network entry.
On the iBOX WebUI, choose
Monitoring > iBOX System > Running Control > Net
Join Config
. There are five configuration methods:
Insert an iBAT
,
Replace an iBAT
,
Delete an iBAT
,
Batch-replace iBATs
, and
Switch iBAT No.
.
Inserting an iBAT
Figure 5-18
Inserting an iBAT
Reference No.
: Indicates the reference node number corresponding to the operation type.
Example: There are three iBATs in the network and they are numbered 1, 2, and 3. Choose
Insert an iBAT
and set
Reference No.
to 2. After the operation, number 2 is reserved, and the
iBAT numbers 2 and 3 change to 3 and 4 respectively.
