9
Click
Basic Settings
, you can configure network and
internet settings.
Network Settings
Click
Network Settings
to go to LAN Interface
configuration page; such as LAN IP and DHCP Server.
All the settings will also apply o wireless LAN interface.
IP Address
: The default IP address of the device is
192.168.1.1.
Subnet Mask
: The combination of the subnet mask and
IP address enables the flexible sub netting. By default,
the subnet mask is 255.255.255.0.
DHCP Server
: It is used to assign IP addresses
dynamically. If the DHCP server is
Enabled
, it can
automatically assign IP addresses for PCs. It is
recommended to select
Enabled
for the DHCP server.
DHCP Lease Time
: The DHCP server automatically
assigns an IP address to each device connected to the
network. When the leased time expires, the DHCP
server checks whether the device is connected to the
network. If the device is disconnected from the network,
the server assigns the IP address to another device.
Thus, the IP address is not wasted.
IP Pool Range
: It is used to define the IP address range
that the host can use during the IP address assignment.
For example, in the network segment 192.168.1.0/24,
the default IP address of the device is 192.168.1.1. The
host IP address can range from 192.168.1.2 to
192.168.1.254. The minimum range is a single IP
address.
The
Start IP Address
must be smaller than or
equal to the
End IP Address
.
If the
DHCP Server
is
Enabled
, the
configurations of
Start IP Address
,
End IP
address
, and
DHCP Lease Time
are valid;
otherwise, you cannot configure them.
IP Address Reservation
Click
Edit Address Reservation
to configure IP
address for specific LAN client by the MAC address.
Please input the
MAC address
of the LAN client PC, and
then specify the
IP address
that will be assigned to the client;
click
Apply
after checking the
Enable
box.
4
Basic Settings
Note
Summary of Contents for D105
Page 2: ...This page is left in blank for note or memo use ...
Page 6: ......
