NOTE
l
When wrapping the waterproof tape, stretch the tape evenly until the tape turns twice its original
length. When wrapping the PVC insulation tape, do not stretch the tape.
l
Wrap each layer of tape tightly and neatly, and ensure that each layer of tape overlaps more than
50% of the preceding layer.
l
Ensure that the side with adhesive tape is covered on the wrapped tape.
l
When cutting off the cable tie, reserve an extra length of 3 mm to 5 mm.
2.6.2 Connecting Optical Fibers and Network Cables
Connecting optical fibers
NOTE
The device can transmit upstream data over optical fibers. The optical fiber is connected to the device using
fiber connectors (purchased independently).
The following figure shows components of an optical fiber connector.
Figure 2-4
Components of an optical fiber connector
(1) Optical fiber
(2) Support
(3) Rubber ring
(4) External connector shell
1.
Select an optical cable of a proper length based on onsite cabling.
2.
Remove the waterproof block from the rubber ring of the connector, as shown in the
following figure.
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
2 AP Installation
Issue 03 (2019-04-01)
Copyright © Huawei Technologies Co., Ltd.
32
