WenZhou ZhengBang Electronic Equipment Co., Ltd
ZB4050LS Rev 1.1
37
5.Select the component that needs to be replenished,
Click on the status bar of the component,
Set the component to be unmounted.
The system in which the status bar has been smashed is considered to be in the mounted state.
Placement is no longer performed in this production process;
The system with the status bar blanked is considered to be unmounted.
Only install the components of this part after starting the program.
Fig.5-10 Unmounted Status
6. Click “Start” to start the feeding production until all the feeding components of this program are mounted.
！
Attention
：
The specified component feeding production is only applicable to the manual identification of Mark points.
To enable automatic identification of Mark point identification, it must be switched to manual identification
or converted to the specified feeder mode for feeding production.
5-4 End & Turn off the Machine
1
、
Click “Exit” to exit the placement machine control system
2
、
Click the Windows Start Menu—Turn off.
3
、
Turn off the power switch on the right side of the main unit to cut off the power.
！
Attention
：
Before turning off the power, be sure to turn off the computer first, otherwise it may cause the computer
malfunction
；
Please ensure that the program has been saved before exiting the system, otherwise it may cause the program
lost.
！
DANGER
：
Click “Start” switch and the machine will start production immediately
；
To avoid body injury, do not put your hands in the machine during operation, and do not move your face
and head close to the machine
；
Be sure that there is no one using the machine before starting the machine
；
Be sure that there is no objects installed in the machine, anything will prevent the machine from running
(adjustment tools, etc.) before starting the machine.
