HTW XKRB1, Owner'S Manual

Page: 30 / 44

6
Operation Instruction
On/Off
Mode Setting
Press the " " button to turn on or off the unit.
In on-state, press the " " button to switch the operation
modes as the sequence shown in below:
Auto Cooling Heating Dry Fan
2)) 21
F
6(7
7(03
$''5
&+(&.
'$< +285
6(7
DRY G-CONTROL FRESH-AIR
Fan Speed Setting
Note:
● After in stallation completed, wired controller will detect the
unit type automatically. Different types may have different
ways of fan speed display, it can be divided into the 2 kinds
above.
● In dry mode, the fan speed is default to low fan speed and
can not be adjusted.
Press " " button, fan speed of indoor unit will change as the sequence below:
2)) 21
)
6(7
7(03
$''5
&+(&.
'$< +285
6(7
'5< *&21752/
FRESH-AIR
Temperature Setting
Press "▲" or "▼" button to increase or decrease setting
temperature in on-state of the unit. If press either of them
continuously, temperature will be changed rapidly.
Temperature setting range is 16°C~31°C (61°F-88°F).
Note:
In Auto mode, the setting temperature is un-adjustable.
2)) 21
F
6(7
7(03
$''5
&+(&.
'$< +285
6(7
DRY G-CONTROL FRESH-AIR
Note:
You cannot set to a mode from the wired controller of the
indoor unit that conflicts with the master wired controller of
an indoor unit.
● When set the auto mode, the indoor fan speed will be changed according to the indoor
ambient temp., The fan speed strip is not displayed.