HTP MicroCut 45 DV, Operator'S Manual

Page: 11 / 23

6
○
8
4.2 Function Introduction
○
1
○
2
○
3
Figure 2.
①
Check whether the cutting torch is connected
② Air pressure light
③
The machine is in working condition
④
Grid cutting mode
⑤ Normal cutting mode
⑥
Gouging/marking cutting mode
⑦ The types of the cutting torch
⑧
Transfer arc/ Arc OK signal
⑨
Cutting parameters which contains air pressure/output voltage/ the recommended
length of the cutting torch
⑩
Cutting current
Tips: The LCD contains two menus. In the first menu, the cutting current and
the cutting mode can be adjusted. To get to second menu, hold down the function
button for 1 second, the cutting parameters flashes. Now it is on the second menu.
If there is no operation for 6 seconds, hold down the function button for 1 second
again, the cutting current display flashes, it will switch back to first menu.
○
6
○
4
○
5
○
9
○
10
○
7