6 | HTC
Connected HOME
Installation Instructions
Step 1:
Install the panel.
The iotega panel will perform best on a flat, stable surface that’s free from vibration and shock, and near:
•
An electrical outlet (no GFCI-protected outlets or outlets controlled by a light switch)
•
A strong cellular signal
•
A strong Wi-Fi signal (if available)
•
Your main point of entry/exit (if preferred)
Step 2:
Power up the system.
1.
Pull out the battery tab from the bottom of the panel.
2.
Connect the power adapter to the back of the panel.
3.
Route the power cable through the strain-relief channel on the bottom of the panel.
4.
Connect the other end of the power adapter into an electrical outlet. (This should not be plugged into
a GFCI-protected outlet or an outlet controlled by a light switch.) The keypad numbers will illuminate
in sequence, and the Power LED will illuminate after approximately 40 seconds.
5.
For extra security, remove the electrical outlet’s plate screw and utilize the attached screw on the
power adapter to secure it in place.
