HT Italia GSC53N, Instruction Manual

Page: 10 / 152

GSC53N - GSC57 - ZG47
EN - 8
3. PREPARATION FOR USE
3.1. INITIAL CONTROL
This instrument has been checked mechanically and electrically prior to shipment.
Any care has been taken to ensure that the instrument reaches you under safe conditions.
You are recommended, however, to carry our a rapid check to detect any possible
damage which might have been caused during transport. Should this be the case,
immediately contact HT Italia.
Check also that the packaging contains all the parts listed under paragraph 15.5. In case
of discrepancies contact the dealer.
In case you have to send the instrument back please follow the instructions reported in
paragraph 16.
3.2. POWER SUPPLY
The instrument can be powered by:
 6 batteries 1.5V AA - LR6 series located in the compartment on the back of the
instrument (not included in the package). For battery life see paragraph 15.3.2.
 an external power supply adapter (code A0050, optional for GSC57) to be used
only for ANALYSER and AUX function . We recommend You to use only A0050 HT
Power Supply adapter.
For your own safety it's not allowed to use the external power supply adapter during
Safety Test (LOW , M , RCD, LOOP, EARTH rotary Switch positions). If you press
the START button the Instrument will show the message "
 REMOVE POWER".
For batteries replacement please refer to paragraph 14.2.
The symbol
shows the battery charge: If it is completely "black" the battery are full
charge, while the symbol indicate weak batteries. When the batteries are too low to
execute the test the instrument will show a warning message.
In the case interrupt testing and replace batteries following the procedure described under
paragraph 14.2.
The instrument is capable of keeping the data stored even though
batteries are not installed. The Instrument Date and Time settings do not get lost if you
change the batteries within 24hours.