Cordless Impact
Wrench
Hand-held cordless impact wrench.
Ideal for tightening and releasing
nuts, bolts and anchors.
Code 67333
Cordless Impact
Wrench
Operating & Safety Guide 322
Operating & Safety Guide 322
322/01
322/01
©HSS Hire Service Group Ltd 2013 No. 322/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
…any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: [email protected]
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so.
Training is available at HSS Training
0845 766 7799
Handle the equipment with care.
Avoid dropping it,
knocking it, or otherwise exposing it to damage.
Never expose the equipment to dangerous and/or
corrosive chemicals.
When battery pack is not in use, keep it away from other
metal objects,
like paper clips, coins, keys, nails, screws or
other small metal objects, that can make a connection from
one terminal to another.
Shorting the battery terminals
together may cause burns or a fire.
Store the battery in a cool, dry place. Never store the
battery where it is exposed to direct sunlight or sources
of heat,
e.g. on heaters / radiators or behind a motor
vehicle windscreen.
Keep the equipment clean
- you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
Avoid working the tool continuously for long periods.
When not in use, store the equipment somewhere
clean, dry and secure.
FINISHING OFF
Switch off the unit by releasing the ON/OFF button then
remove the socket and battery pack.
Clean the tool up as far as possible, paying special
attention to the motor’s ventilation slots.
Place the unit and the battery in the carry case
ready for
return, to HSS Hire.
BASIC TECHNIQUES
seen in the working direction) for forward rotation. Push
the forward / reverse switch to the left (as seen in the
working direction) for reverse rotation.
The speed of the power tool can be controlled smoothly
(increased from minimum to maximum) by pressing the
control switch gradually.
Battery type
Li-Ion
Battery capacity
2.6 Ah
Energy content
56.16 Wh
Full hammering frequency
2500 impacts/minute
Max. torque
450 Nm
Dimensions (LxWxH)
232 x 94 x 258 mm
Weight
3 kg
Driving standard bolts
12mm - 24mm
TECHNICAL SPECIFICATIONS
Never push the equipment beyond its design limits.
If it
will not do what you want with reasonable ease and speed,
assume you have the wrong equipment for the job. Contact
HSS Hire for advice.
EQUIPMENT CARE
R
L
Forward rotation
Reverse rotation
Locked
Before starting work, survey the work area and use the
correct type of tool.
Make sure you are in comfortable position. The correct
position allows you to work easier and provides better
results.
Do not apply excessive pressure. This will not increase
the performance. This is not a drill.
When the impact socket will not do what you want, assume
you have wrong bit fitted. Change it to correct one.
When you have finished a work session, release the ON/OFF
trigger switch, let the tool stop spinning, remove the bit
and move the directional selection slider to the middle
position. Place the tool in a safe place.
If when using the tool the power begins to fade the battery
requires re-charging, remove the battery and recharge as
described in the GETTING STARTED section.
