HSM VK 5012, Operating Manual

Page: 27 / 96

6.417.999.120
VK 5012 Installation
Issued 06/2005
4.3
4.2 Installation conditions
4.2.1 Space requirement / foundation
It must be ensured that there is enough room around the baling press to make the
installation and repair work easier. Machines connected to the baling press must be
positioned accordingly.
The load on the foundation at the operating site must be sufficient.
The installation on the prepared foundation must be such that the baling press
stands evenly -> Use a spirit level! Level off the floor as necessary.
The vibration dampers of the machine must be screwed onto the floor
-> Use heavy-duty plugs.
4.2.2 Installation personnel
Warning!
The baling press my only be assembled or dismantled under the
supervision of an HSM service engineer.
4.2.3 Operation outdoors
Warning!
Put into operation only under supervison.
The operator must ensure that unauthorized persons do no have
access to the baling press.
When the baling press is not operated it must be shut down and
secured against unauthorized use.
– the baling press must not be directly exposed to rain.
– the maintenance intervals must be reduced
– if the temperatures drop below 0
°
, use hydraulic oil with a suitable viscosity, if
required.
4.3 Supply connections
A suitable electric power supply with a corresponding fuse protection must be
present at the installation site.
(see "Technical data")
Attach a protection against rain water when the baling press is operated outdoors.
The power supply must fulfill the requirements for installation outdoors.
(additional
FI protection)