Page 8
Huddle Hub Installation Guide
3.2 Installation guidelines
When installing HHO, please follow these important guidelines:
·
The product should not be located in a place where it will be exposed to moisture or excessive heat.
·
Place your HHO unit in a well-ventilated place, far from any heater or heating vent.
·
Avoid direct irradiation of any strong light (such as sunlight) and keep at least 5 cm (2 inches) of
clear space around your device.
·
Place HHO horizontally for optimal heat dissipation. HHO can be installed vertically with front panel
up. Vertical installations with front panel facing left or right don’t allow correct heat
dissipation and must not be used.
·
Do not place this equipment on an unstable cart, stand, or table. The product may fall, causing
serious damage to it.
·
Place HHO in a location where it can be connected to a power source, and to TV and webcam (if
required).
·
Make sure the cables and power cord are safely placed out of the way, so they do not create a
tripping hazard.
·
Keep the product away from devices with strong electromagnetic reference, such as cordless
phones and microwaves. To access your HHO through its Ethernet interface, the unit must be
connected to the company LAN using an Ethernet cable.
Power Cord and AC-DC Adapter
The power cord is country specific, to be compatible with your country AC sockets.
The supplied AC-DC adapter input voltage range is 90 – 264 VAC and the output is 12V – 5A - 60W.
Warning: You are required to use the supplied AC-DC adapter only.
L-shape and VESA mounting kit, screws kit
The L-shape mounting kit can be used to secure the unit on walls, tables, rack cabinets, etc.
The VESA mounting kit allows to install HHO+ on TV screens or any other device which follows the
VESA mounting standard.
The screws kit contains screws for both the mounting kits.
Wi-Fi antennas (HHO+ only)
The two supplied antennas work for both 2.4 and 5GHz Wi-Fi bands. The gain is 2.0db and the
impedance is 50ohm.
